MIZZY INC -- SILICONE EMULSION  -- 6520-00N049604
<pre>=====================  Product Identification  =====================

Product ID:SILICONE EMULSION
MSDS Date:11/30/1992
FSC:6520
NIIN:00N049604
=== Responsible Party ===
Company Name:MIZZY INC
Address:616 HOLLYWOOD AVE
City:CHERRY HILL
State:NJ
ZIP:08002
Country:US
Info Phone Num:609-663-4700
Emergency Phone Num:800-535-5053
CAGE:04685
=== Contractor Identification ===
Company Name:MIZZY INC
Address:616 HOLLYWOOD AVE
Box:City:CHERRY HILL
State:NJ
ZIP:08002
Country:US
Phone:609-663-4700
CAGE:04685

=============  Composition/Information on Ingredients  =============

Ingred Name:POLYDIMETHYL SILOXANE; (SILICON RESIN)
CAS:9016-00-6
RTECS #:TQ2690000
Fraction by Wt: 95%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Ingred Name:SUPDAT: OCCURS, NOTIFY PROPER AUTH AS REQD, THAT A SPILL
    HAS OCCURRED. DISPOSE WASTE I/A/W ALL LOC, ST & FED REGS.
RTECS #:9999999ZZ

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:ACUTE: EYES: MAY CAUSE IRRITATION.
    INHAL: EXCESSIVE INHAL OF VAPS CAN CAUSE NASAL AND RESPIRATORY
    IRRITATION. INGEST: CAN CAUSE GI IRRIT, NAUS, VOMIT & DIARR. SKIN:
    MAY CAUSE IRRITATION.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:EYES: FLUSH WITH LARGE AMOUNTS OF WATER FOR AT LEAST 15
    MINUTES, LIFTING LIDS OCCAS. INHAL: REMOVE TO FRESH AIR. INGEST:
    IMMED DRINK 2 GLASSES OF WATER AND NDUCE VOMIT BY EITHER GIVING
    IPECAC SYRUP/BY  PLACING FINGER @ BACK OF THROAT. NEVERGIVE
    ANYTHING BY MOUTH TO AN UNCON PERSON. GET MED ATTN. SKIN: THORO
    WASH EXPOSED AREA WITH SOAP AND WATER. REMOVE CONTAMD CLTHG & HAVE
    LAUNDERED BEFORE RE-USE.

=====================  Fire Fighting Measures  =====================

Flash Point:610F,321C
Extinguishing Media:REGULAR FOAM/CARBON DIOXIDE OR DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA AND FULL
    PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:NEVER USE WELDING OR CUTTING TORCH
    ON/NEAR DRUM (EVEN EMPTY) BECAUSE PRODUCT (EVEN JUST RESIDUE) CAN
    IGNITE EXPLOSIVELY.

==================  Accidental Release Measures  ==================

Spill Release Procedures:SM SPILL: ABSORB LIQ ON PAPER, VERMICULITE,
    FLOOR ABSORB/OTHER ABSORB MATL & TRANSFER TO HOOD. LG SPILL: ELIM
    ALL IGNIT SOURCES (FLARES, FLAMES INCL PILOT LIGHTS, ELEC SPARKS).
    PERSONS NOT WEARING PRO T EQUIP SHOULD BE EXCLUDED FROM AREA
    OF(SUPDAT)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:NONE SPECIFIED BY MANUFACTURER.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF OVEREXP HAS BEEN DETERMINED OR DOCUMENTED, A
    NIOSH/MSHA APPROVED AIR SUPPLIED RESPIRATOR IS ADVISED IN ABSENCE
    OF PROPER ENVIRONMENTAL CONTROL.
Ventilation:PROVIDE SUFFICIENT MECH (GEN &/OR LOC EXHST) VENT TO
    MAINTAIN EXPOS BELOW LEVEL OF OVEREXP.
Protective Gloves:RESISTANT GLOVES SUCH AS NEOPRENE.
Eye Protection:ANSI APPROVD CHEM SPLASH GOGGLES .
Other Protective Equipment:NORMAL WORK CLOTHING ARMS AND LEGS.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
SPILL PROC: SPILL UNTIL CLEAN-UP HAS BEEN COMPLETED. STOP SPILL @
    SOURCE, DIKE AREA OF SPILL TO PVNT SPREADING, PUMP LIQ TO SALVAGE
    TANK. REMAINING LIQ MAY BE TAKEN UP ON SAND, CLAY, EARTH, FLOOR
    ABSO RB/OTHER ABSORB MATL & SHOVEL INTO CONTRS. PVNT RUN-OFF TO
    SEWERS, STREAM/OTHER BODIES OF WATER. IF RUN-OFF (ING 2)

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:300F,149C
Vapor Pres:5
Evaporation Rate &amp; Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE WASTE WITH ALL LOCAL, STATE AND FEDERAL
    REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.